FG-100 FG-200 DDS Function Signal Generator Frequency Counter 0.01Hz - 500KHz Signal Module Sine+Square+Sawtooth Waveform(FG-200)

Digital Signal ProcessorsFG-200 DDS Signal GeneratorI.The main technical parameters:1. Output waveforms: sine wave, square wave, triangle wave, forward sawtooth wave, reverse sawtooth wave, ECGwave, exponential rise, exponential fall, Lorentz pulse, Gauss pulse, Sinc pulse, half-wave, fll-wave, Schumann wave, noisewave, and so on 15 kinds of waveforms.2. Power supply: DC4-9V, DC5V is recommended when using adapter, 3.7V lithium battery is recommended when usingbattery power.3. Current: 180MA at voltage 5V4. Frequency range: sine wave 0.01Hz- 500.00kHz (with further increase in frequency, the output amplitude willdecrease), other waveforms 0.01Hz-100.00kHz (but does not limit the upper limit of the adjustable frequency, if thedistortion and jitter requirements are not high, the use of frequency can be further increased).5. Resolution: 0.01Hz.<;1% below 1kHz, 0.5% above 1kHz.7. Output amplitude: Maximum t10V (P-P).8. output impedance: 50 ohms.9. DC offset: maximum10V, with shutdown function.10. All setup parameters can be saved.11. there are filters can be turned on and off, can be well adapted to sinusoidal and pulse waveform output.II .Features:Compact size (125*80* 26.5MM),complete functions, simple operation, easy to carry. It can bepowered by a power adapter or a 3.7V lithium battery. Together with an oscilloscope, it can be used for electronic circuittest and debugging, frequency characteristics and impulse response test and measurement of audio amplifiers. Due to thegood accuracy and frequency stability of DDS, it is also very suitable for oscilloscope sweep time factor calibration. Thesquare wave output is suitable for oscilloscope attenuator and probe pulse characteristic adjustment.FG-100 DDS Signal GeneratorSmall size, multiple functions, simple operation, easy to carry.ith an oscilloscope, which can be used in electronic circuit experiment and debugging, the frequencDue to the good precision of DDS and frequency stability, is also very suitable for oscilloscope sweCOLOR:whiteMaterial:metalWith an oscilloscope, which can be used in electronic circuit experiment and debugging, the frequency characteristics of audio amplifier and pulse response of test and measurement.Due to the good precision of DDS and frequency stability, is also very suitable for oscilloscope sweep time calibration factor. Square wave output also suit for oscilloscope attenuator and probe pulse adjustment, etcThe main output waveform : sine wave and square-wave, Triangular wave, sawtooth wave.Maximum output amplitude : +/- 10Vpp (no-load)Output impedance : 50Ohm+/-10%Dc bias : +/- 10V (no-load)Display : LCD1602Material:metalResolution : 1 HzPower supply : DC 3. 5-10VOutput frequency range :Sine wave : 1Hz-500KHzSquare-wave : 1 Hz - 20kHz (the valid range)Triangular wave : 1 Hz - 20KHz (the valid range)Sawtooth wave : 1 Hz - 20kHz (the valid range)==========Battery Included : NoHigh-concerned chemical : NoneModel Number : FG-100/FG-200DIY Supplies : ElectricalCertification : Display Size : 3.0 - 4.9 Inches

• Digital Signal Processors
• FG-100 FG-200 DDS Function Signal Generator Frequency Counter 0.01Hz - 500KHz Signal Module Sine+Square+Sawtooth Waveform